Using the Redirector :: The Serial/IP Control Panel

DTR is Modem Escape

The Serial/IP Redirector can simulate DTR signal transitions.

To set DTR is Modem Escape

In the Serial/IP Control Panel:

1. Select a virtual COM port.

2. Select the check box DTR is Modem Escape.

3. In the drop-down list, select an emulation method.

4. The setting becomes effective without further action.

The new setting will be used the next time this virtual COM port is opened.

Tips

The default setting is disabled.

 Notes

If the Configuration Wizard detects server support for the COM Port Control protocol, this option has no effect.

  Related Topics

Installing the Redirector: Finish the Port Settings

The Configuration Wizard: Using the Configuration Wizard

System Requirements: Server Requirements | Checklist for All Applications